Look and listen! That’s the best advice to give to homeowners wishing to have control over garage door problems. No noise is excused unless it comes from the chain drive garage door opener. No corrosion should be allowed for the avoidance of more problems. But with repeated opening and closing cycles daily, parts wear. Over the years, steel parts are affected by humidity and corrode. With the overhead door moving up and down, fasteners get loose. The door might lose its balance and the old lubricants will eventually dry out.
In other words, disaster! The garage door will start making noise and might not close well. Garage door opener problems might also keep it open. There comes a time when you are fed up with daily complications or fear for your safety. And the best solution to avoid hassle or even taking risks is garage door maintenance. And these are not the only advantages of preventive services. With annual inspection and service, what you gain is energy too. Because if the door stays open even by a few inches or the weatherstripping is damaged, you will waste energy.
Why leave garage door service to the pros
Let us just say that any garage door maintenance service should be performed by pros. And that’s because such services don’t merely include inspections. They also include repairs and adjustments and might involve interfering with the spring system in order to balance the door. And such tasks can be risky if you are not an expert in garage door repairs.
6 simple maintenance tips
But since you need to know when it’s time to maintain the garage system, let’s see which are the signs indicating some wear and what you can do.
- Press the button to operate the door and observe its movement. Does it open and close entirely? Does it make strange sounds? It should go all the way up and shut down perfectly. And it shouldn’t be noisy unless it needs lubrication.
- But noise doesn’t only indicate the need for lubes. It might be a sign of spring problems. It might be a warning that some screws, nuts, and bolts are not tightened. And they should be. If not, the tracks will fall out of alignment and the door might jam.
- Check the garage door cables. If they’re frayed, they must be replaced. They must be in perfect condition, wrapped around the drums, and properly attached to the bottom brackets. If it’s not, don’t touch them. You will release the tension of the springs and might get seriously hurt.
- One thing you can do is test the door balance. Pull the release cord to disconnect the opener and open the door to your waist. If it doesn’t stay put, the springs must be adjusted. But don’t do it yourself.
- You can also test the reverse system. In two ways. First, put an object on the floor. The door should reverse after coming in contact with the object. Second, let the door come down and pass your hand under it. It should stop and reverse.
One last thing you can do is clean the garage door tracks if debris has built-up. And sweep any dirt from the floor since the sensors might be fooled and keep reversing the door.